![]() The Y axis frames and the X axis gantry of the X-Carve are made of extruded aluminum. You might find daredevils who have done this, but this CNC is absolutely not the machine for milling steel. But this holds true for most desktop CNC machines at this price range. However, there's the chance of the waste board getting soaked if the coolant drips out of the aluminum sheet.Īlso, cutting steel is out of the question with the X-Carve. Just to give you a rough idea of how fast you'll be able to cut on aluminum, with the depth of cut at 0.25mm (0.010"), you can get an accurate cut with a feed rate of 40 ipm.įor improving your results on aluminum with X-Carve, you need to have a system to remove the chips immediately as they get generated and also use a lubricant to lower the heat. You need to carefully control the depth of cut, feeds and speeds to get good results on aluminum with the X-carve. This software can tell you how much time it will take to complete the operation based on your design and the material. The software that's commonly used with the X-Carve is Easel. Like most CNCs in this category, the X-Carve can mill a variety of materials like hardwood, softwood, MDF, plastics, and PCB among other materials.įor aluminum, inventables recommends using the X-Carve only on the alloy 6061. Material Capability X Carve CNC working on hardwood If this clearance is not enough for you, then you can get the "Z-axis kit" for the X-Carve which adds an extra 2" height to the Z-axis for you to work on. In any case, the thickness of your material plus bit length should not exceed 67mm.įor instance, if you just want to engrave on your material, you could squeeze in a 57mm thick material with a 10 mm bit. If you use a smaller bit, you can get away with using material thicker than 1.25". However, for a through cut (full depth cut) you can use a 1.25" (or less) thick material on the X-Carve. The maximum thickness depends on the bit length as well, apart from the spindle height. What's the maximum material thickness that you can carve using this machine?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |